I am currently working with the TMS320F28335 microcontroller and using the Example_2833xSci_FFDLB_int.c example code. My goal is to configure the system so that data is transmitted on the TX pin only ...

In theory this should be possible since LIN is a single wire protocol. However, we do not have a plan to support this.

Check the generated file test.json, the 0x34, 0x38, 0x3C are configured to select PDM1 PDM1 and echo as channel0, channel1 channel2 in the I2S/TDM commnuication. 6. Copy the test.bin to the kernel and ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I'm working on an audio recording setup using an Android device with a PCMD3180 PDM-TDM converter that supports 8 DMIC inputs. Despite configuring all 8 channels for recording, only 4 channels are ...

I was finally able to load and run U-Boot. Anyway the dtb/Linux loading process keeps on failing and I fall back into U-boot console. Here's the log I get: U-Boot SPL 2024.04-dirty (Sep 30 2024 - ...

I was simulating a circuit which contains all AD parts. I found the the alternate TI parts and started simulation in tina ti . The results I obtained in both simulations are entirely different . Op ...

My project using TDA4 VM + SDK 9.1 + EMMC boot. Emmc device type is MTFC32GASAQHD-AAT. EMMC boot is normal without special operations.But emmc boot gets stuck when I do the following operation，These ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I read that the packet sniffer 2 software contains the firmware that enables CC13xx launchpads to be used as capture device. Source: https://dev.ti.com/tirex/explore ...

Model quantization uses int16 quantization, which has better results, but int8 quantization is poor. How to locate which layer is causing the difference? Found a problem: need to remove the mal, sub, ...

We are using THS4521 for converting single-ended to differential signal. Differential signals are going out of the board via ethernet cable to MCU ADC on the other board. - MCU ADC configuration is in ...